Tools
Overheating / throttle test
Check if your PC or gaming laptop slows down when it gets hot. The test keeps every processor thread busy for a few minutes, optionally loads the GPU too, and shows whether the speed at the end matches the speed at the start. No download, nothing uploaded.
Overheating / throttle test
Keeps every processor thread busy for the time you pick and records how much work gets done each second. If the line falls as the run goes on, the device is slowing itself down under sustained load. Everything runs in this tab; nothing is uploaded.
Logical processors reported
Not reported
Your browser cannot read temperatures, clock speeds or fan speeds. This test only sees how much work gets done over time. To see the actual temperatures, keep a hardware monitor such as HWiNFO open while it runs. Fans getting louder and the device getting warm during the test is normal; press Stop at any time.
Browser JavaScript is not native code, and the power plan, battery mode, room temperature and background apps all change the result. Compare runs on the same device and browser, before and after one change.
How to use the throttle test
- Plug a laptop into power and put it on a hard, flat surface such as a desk. Close games, video exports and other heavy apps.
- If you want to see temperatures, open a hardware monitor such as HWiNFO next to the browser. The page itself cannot read them.
- Pick the test length. 5 or 10 minutes is a real heat test; 1 minute is a quick check. Turn onAlso load the GPU on a gaming laptop to heat it the way a game does.
- Press Start throttle test and keep the tab in front. If you switch tabs, the test pauses, because browsers slow down background tabs. Stop and show results ends the run early with the data so far.
- Read the chart, the change start → end and the verdict. Press Copy results to paste them into a forum post, then change one thing and run again.
What thermal throttling is
Processors and graphics chips change their clock speed all the time. When there is room, they boost above their base speed. When the chip reaches its temperature limit, or the power limit the maker set, it lowers its clock speed and voltage to stay within that limit. That is throttling. It protects the hardware, but it also means fewer calculations per second, which in a game shows up as a lower or less even frame rate.
Some slowdown is part of the design. Many processors boost hard for a short time and then settle at a lower speed they can hold, and thin laptops and small PCs have less room for coolers, so their sustained speed sits further below their short boost. A problem is when the speed keeps falling, or when a desktop that used to hold its speed no longer does.
This page measures the effect, not the cause. Each worker repeats a fixed mix of integer math, floating point math and memory work, and the page counts how many rounds finish every second. If the same work takes longer later in the run, the device slowed down. Heat is the usual reason, but a power limit, a battery mode or a background app can do the same thing.
How to read the result
- No sign of throttling: the end of the run is less than 5% slower than the start. The cooling and the power limits keep up with this load.
- Boost faded, then steady: the best 10 seconds, usually right at the start, were clearly faster than the rest, but the run then held a steady speed. This is common on laptops and is usually by design.
- Mild slowdown (5–15%): the device lost some speed as it warmed up. Worth checking the power mode and the cooling.
- Throttling likely (15% or more): the end of the run was much slower than the start. Look at temperatures in a hardware monitor while you run the test again.
- Unsteady speed: the average held, but the line jumped up and down. Background apps and power-saving modes are common causes.
The start and end windows are each a quarter of the measured run, up to one minute, and are shaded on the chart. The first two seconds are left out while the workers start. The thresholds and the 0–100 stability score are this page's own rule of thumb, relative and uncalibrated. Run the test two or three times and compare like with like: same length, same thread count, same power settings.
What to do if your PC or laptop throttles
- Plug in and pick a performance mode. On Windows 11, open Settings, then System, then Power & battery, and set Power mode to Best performance while plugged in. Laptop maker apps often have their own quiet, balanced and performance modes as well.
- Give it air. Keep a laptop on a hard surface with its vents clear, not on a bed or a sofa. Raising the back a little can help laptops that take air in from below. Keep a desktop case away from walls that block its intake or exhaust.
- Watch the temperatures. Run the test again with HWiNFO or a similar monitor open. If the temperature sits at its limit while the clock speed falls, cooling is the bottleneck. If the temperature is fine but the speed still drops, look at power limits and power modes instead.
- Clean the dust. Dust in fans, heatsink fins and case filters slowly blocks airflow. Clean them with the device switched off and unplugged.
- Cut heat you do not need. In games, capping your FPS near your monitor's refresh rate stops the hardware from drawing frames the screen cannot show, which lowers heat and noise.
My guides go deeper: gaming laptop cooling covers the surface, the power limit and cooling pads, gaming PC cooling explains the path heat takes out of a desktop, and airflow PC cases helps if the case itself is the limit. If your games feel uneven rather than slow, read about 1% low FPS, and for free wins see how to increase FPS.
Common questions
Can this test show my CPU or GPU temperature?
No. Browsers do not give web pages access to temperature sensors, clock speeds or fan speeds. The test only measures how much work gets done each second. To see temperatures, keep a hardware monitor such as HWiNFO open while the test runs and watch it next to the chart.
How long should I run it?
Five or ten minutes. A cooler and a laptop chassis take a few minutes to heat up, so a one-minute run mostly shows the short boost at the start. Use one minute as a quick check that everything works.
Is it safe to run?
Yes. It is ordinary JavaScript work that keeps the processor busy, the same kind of load as a game or a video export. Processors and graphics cards protect themselves by slowing down when they reach their limits. Fans will get louder and a laptop will feel warm. You can press Stop at any time.
Why is the end of the run slower on battery?
Many laptops allow the processor less power on battery to save charge, so the sustained speed is lower. Plug the laptop in and set Windows to Best performance before you test.
Should I turn on the GPU load?
On a gaming laptop, yes. In games the processor and the graphics chip often share one cooling system, so testing both together is closer to a real gaming session. On a desktop, leave it off to look at the processor alone, or turn it on to see if the whole case heats up.
Why did my result change when I switched tabs?
Browsers slow down tabs that are hidden, which would look like throttling. The test pauses when the tab is hidden and marks the pause on the chart. The processor also cools during a pause, so an unbroken run gives the cleanest result.
Is the stability score comparable with other benchmarks?
No. The 0–100 score is this page's own relative, uncalibrated rule of thumb: how much of the best 10-second speed is still there at the end of the run, where keeping 95% or more counts as full marks. Use it to compare your own runs before and after a change.
Related tools and guides
- Sensitivity converter — Convert sensitivity between Overwatch, Valorant, CS2, and other titles using documented yaw values.
- cm/360 calculator — Turn mouse DPI and in-game sensitivity into centimeters per 360° turn.
- eDPI calculator — Multiply mouse DPI by in-game sensitivity for a same-game comparison number.
- FOV converter — Convert horizontal and vertical FOV across 4:3, 16:9, 16:10, and 21:9. Includes Overwatch, CS2, and Valorant.
- Frame-time and Hz calculator — Convert FPS to milliseconds, compare that wait to the monitor refresh, and read a 1% low as a frame time.
- Mouse polling-rate tester — Measure how often the browser sees pointer events. Average and max Hz.
- Mouse raw input test — See every mouse report as a dot, spot sensor skips, and check jitter, swipe speed, and acceleration.
- Mouse test — Check mouse buttons, the scroll wheel, double-click chatter, and a pointermove polling-rate reading in the browser.
- Keyboard test — Press keys on a US QWERTY board, then time your typing on real sentences or random letter strings.
- Gamepad test — See every controller button, analog trigger and stick live, check stick drift with a suggested deadzone, and test vibration.
- Processor test — Single-thread and all-thread CPU speed, scaling and a short stability check.
- Graphics test — Detect your GPU and run a relative WebGL2 benchmark.
- Memory test — RAM read, write and copy speed, latency and a cache-step chart.
- System info — OS, browser, GPU, CPU threads, RAM and screen your browser reports.
- Bottleneck / FPS estimator — Check if the CPU or the GPU holds your FPS back, from usage you measured.
- Best budget gaming laptop — What to look for if your laptop cannot keep up anymore.
Comments
No comments yet. Be the first to share what you think.